Have you picked a new weed eater from Weed Eater Geek? After making your selection it’s important to then take steps to keep yourself as safety as possible. Here are some helpful tips:
- Check for parts that need replacement
It’s important to check the weed eater from time to time for parts that need to be replaced. They include loose belts and damaged guards. These are important parts mentioned at Weed Eater Geek that can cause safety issues so it’s worth the time needed to check them to determine if repairs or replacements are required.
- Keep the nylon string below waist height
It’s important that the nylon string isn’t used higher than waist height. This will to keep both the operator and anyone around it safe. The nylon is spinning quite fast so it’s critical to stay at a safe distance. That involves not only how far away you are from the spinning nylon but also how high it’s operating.
- Don’t use a higher speed than necessary
Make sure you don’t use a faster speed than necessary to cut the small plants. The reason is it could cause a lot of flying debris if you use a speed that’s too fast. Besides that, it would also increase the chance that non-vegetation could also fly up, such as small rocks.
- Add fuel properly
This is an important step to take that might be mentioned at Weed Eater Geek. There are various steps you can and should take. For example, make sure that you’re using the right mixture when operating a 2-cycle weed eater. Some examples include 50:1 or 40:1 (gas/oil) but it depends on the particular unit. It’s important to make sure this ratio is correct to make sure you’re getting the best results.
Another important step when dealing with the unit’s fuel is to allow the engine to cool down before you add fuel. That will help to avoid safety issues caused by fuel and a hot motor. That’s definitely a situation you’ll want to avoid as it could cause combustion.
- Get good footing before you start up the unit
Make sure to grip the unit with two hands and make sure your feet are steady before you start up the machine.
- Stop the unit if it gets snagged on something
It’s one thing if the weed eater struggles a bit to cut thick weeds. In fact, you might have to do a few passes in order to trim tough weeds. However, it’s quite another story if the unit gets snagged by big rocks, twigs, and other items. The spinning nylon could cause the debris to fly up, which is a situation you’ll want to avoid. So it’s important to switch off the unit immediately if the nylon gets caught on something.
These are some helpful tips to keep yourself as safe as possible after selecting a weed whacker from sources such as Weed Eater Geek. They’ll help to make sure you’re as safe as possible when operating a string trimmer.